Fiber Glass Aqua Tri Cycle
FiberGlass Aqua Tri Cycle
To break out of the city into nature, go fishing, relax with friends, go skiing or wake board – for this, it’s better not to come up with a boat. Buy a luxury car, and then buy a boat – this is undoubtedly a lifestyle, status, part of the image. Before you buy a FIBERGLASS tri cycle, you should pay attention to its characteristics: size, availability of a cabin, engine power. But, first of all, all watercraft are divided according to the material from which they are made. There are multiple sizes and dimensions available for Fiber glass boats.
Why fiberglass, not metal? Let’s take together all the advantages and disadvantages, so:
It is well known that fiberglass boats have very good performance properties – they are lightweight, durable with low weight, waterproof, thanks to their water-repellent and anti corrosive properties, they do not decay and do not rust, and at the same time they require minimal costs in preparing for the new season and in everyday use.
The hull of a fiberglass boat does not swell in water, because it has chemical, dielectric and thermal resistance – that is, its mass does not increase from getting wet – thus, the boat can serve for a very long time – up to 25 years.
One of the main advantages is that the fiberglass boat has the ability to manufacture any matrix, and therefore complex bottom surfaces that cannot be reproduced from metal. As a result – improved hydrodynamics, seaworthiness and speed.
The maintainability of the plastic is quite high, even deep scratches on the body can easily be polished, and the hole can be repaired quite quickly.
An equally important characteristic is the reliability and safety provided by the buoyancy compartments, strong plastic, hull power kits, passenger handrails and railings. The high side and the windshield protect the cockpit from spray, the awning from rain and sun.
Resistance to ultraviolet and negative atmospheric influences allows you to create a wide selection of color palettes thereby satisfying the requirements of the most demanding customer.
At the same time, the quality of manufacturing a fiberglass boat is undoubtedly of great importance, since with improper design and non-compliance with technologies during use, the following significant disadvantages of a fiberglass boat can appear:
Fiberglass boat hull wears out significantly during friction. This is most typical for sheathing at the stem and along the corners of the transom, for the sharp edges of the cheekbones. In addition, the boat’s plastic can wear in places where moving parts made of metal or wood come into contact with it, as well as mooring cables. Therefore, if the hull of a fiberglass boat does not have serious protection against abrasion, then pretty soon the boat may require a thorough repair.
The outer decorative layer of the hull of a fiberglass boat may not be strong enough and resistant. As a result, the open surface of the reinforcing fiberglass fabric can wear out under mechanical damage, under the influence of the environment, or when the hull of the boat is deformed.
If the technology is not followed and the fiberglass fabric is of poor quality, the strength of the fiberglass may be insufficient, which can lead to leaks in the connection between the boat hull and deck sections. In addition, non-glued areas and air bubbles may remain in the lining between the layers of the fiberglass fabric, which can subsequently cause the leakage of the fiberglass boat.
A fiberglass boat (boat, yacht), like any other, requires constant monitoring, careful maintenance and preventive maintenance, taking into account the features and properties of the material from which it is made.